Carseum Dash - flush vent insert for BMW E90/E92/E93 (right-hand drive)

!!! The vent sizes are ESTIMATES. Print the FIT TEST first, nothing else. !!!

STEP 1 - print now:
  e93-vent-pod-fit-test.stl   about 20 min, about 5 g
  - PETG or PLA is fine for this test, no supports, flat on the bed.
  - It is an outline frame of the vent outlet + a small plate for the board.
  - Hold the frame against the driver-side centre vent outlet (or push it
    into a spare vent's empty outlet). Send photos: too big / too small /
    corners off? I'll correct the numbers.

STEP 2 - only after the fit test is right (new files will be sent):
  e93-vent-pod-shell.stl      the insert itself
    - ASA (best) or PETG, MATTE BLACK. Not PLA (warps on a hot dash).
    - 0.12-0.16 mm layers, 4 walls, 30% gyroid.
    - BACK DOWN, face up. Tree supports INSIDE the hollow body only.
  e93-vent-pod-ring.stl       clamp ring that holds the board
  e93-vent-pod-cover.stl      back cover that seals the screen from the vent's air
    - Both flat on the bed, no supports, 0.2 mm layers, same material.

Hardware: 2x M2 x 6 mm self-tapping screws for the ring.

Thanks!
